Overview

• Purpose-built mounting feet that secure your BubbleTek to any lift cart or table.

• Dramatically reduces tipping risk during loading, agitation, or transport.

• Fully removable — maintain mobility when you need it.

• Fits all 20 and 30 gallon BubbleTek units.

• Early launch units may have slightly smaller foot sizing; verify 3 9/16″ OD on the feet if unsure.

Why You Want This

• Safety: Stabilizes your BubbleTek even under heavy load.

• Confidence: Prevents tipping when working solo or with full-weight ice/water loads.

• Workflow Efficiency: No wobbling, shifting, or repositioning mid-wash.

• Compatibility: Uses the same tri-clamp system found throughout the BubbleTek platform.

• Flexibility: Works with most lift carts and worktables.

Installation Guide 

Installation is straightforward and can be completed with basic tools. While the video shows Aleks doing it solo, two people are recommended for safety.

1. Trace the Footprints

• Place your BubbleTek exactly where you want it mounted.

• Use a dry-erase marker or pencil to trace the bottom of the BubbleTek feet themselves.

• No need to pre-attach the mounting feet prior to tracing.

2. Remove the BubbleTek

• Carefully tip the unit onto its side.

• Place each mounting foot inside the circles you drew.

3. Mark the Center Holes

• Mark the bolt-hole centers while each mounting foot is aligned to its traced outline.

4. Check Underneath Before Drilling

• Look underneath your lift cart or table to ensure your center marks do not land directly on a support brace.

• Adjust foot placement slightly if needed.

• If you are using a Hashtek Lift Cart, you can follow the video exactly — the spacing is ideal.

5. Drill the Holes

• Start with a smaller drill bit, then step up to 5/16″ (8 mm).

• Use a bit of cutting oil to make drilling smoother and cleaner.

• If your fit-up is slightly off, enlarge the hole to 3/8″ (9 mm) to allow micro-adjustments before final tightening.

6. Bolt the Mounting Feet Down

Hardware order (bottom → top):

Acorn Nut → Lock Washer → Flat Washer → Lift Cart/Table → Mount Foot → Bolt

Notes:

• If a support brace is too close for the flat washer to fit, simply omit the flat washer.

• The lock washer is the important piece for preventing loosening over time.

7. Mount the BubbleTek Onto the Installed Feet

1. Place the gaskets on top of each mounting foot.

2. Lower the BubbleTek onto the mounted feet (two people recommended).

3. Attach the clamps, positioning them so they overhang the edge of your lift cart/table — this ensures enough room to tighten the thumb nut.

4. Tighten the clamps securely.

5. If space is tight (large carts or thick tables), replace the thumb nut with a 5/16″ hex nut for easier tightening.

Included

• 3× Stainless BubbleTek Mounting Feet

• 3× Tri-Clamp Gaskets

• Optional hardware kit (if included in your SKU)

• Video tutorial + written instructions

Notes

• Mounting feet are fully removable.

• Verify the 3 9/16″ OD on early BubbleTek units.

• Recommended for all setups using a lift cart for agitation.

Please leave this field empty

Don’t miss any blog posts!

This field is required.

Check your inbox or spam folder to confirm your subscription.